Viking range repair is the work on the cooktop half of a Viking range — sealed burners, spark ignition, low-flame settings and the griddle — kept apart from its oven.
as used by Viking Appliance Repair Edmonds, (206) 210-3547
Kitchen Viking service · Edmonds
Viking Range Repair in Edmonds: Burners, Ignition, Griddle
Burners are the part of a Viking range an Edmonds kitchen uses every day, so a burner that clicks without catching is usually the first fault an owner notices.
| What you notice | Measured first |
|---|---|
| Burner clicks and clicks but never catches | Gas at the ports confirmed by the technician, then the electrode and the cap seating |
| Lowest setting lets the flame go out | Flame watched at the bottom of the dial with the cap seated, then the valve |
| Yellow flame that leaves soot on the pan | Cap position and blocked ports checked cold, then the burner's air supply |
| Griddle will not hold its set temperature | Plate temperature measured against the dial, then its thermostat and igniter |
Cooktop first
A burner that will not light is almost always an ignition or cleanliness question — a damp electrode, a cap sitting askew, ports closed with residue — and it is settled at the cooktop before any panel comes off. When a part is needed, it is usually an electrode, a switch or the spark module, and the burner igniter band covers the commonest of them. The griddle is handled the same way: temperature first, parts second.
Where the range sits
Say on the phone if the range is fitted tight into an older cabinet run, in a Westgate split-level or anywhere else, because a range that has to come forward for the repair changes how the visit is planned.
Between visits, the burner caps and electrodes are part of the once-a-year kitchen check.
What it costs
Where range repair sits on the published bands
Each row is parts and labour together for one family of job. Where a repair lands inside its row depends on the exact part and how deep in the appliance it sits, so nothing here is a single headline number.
- Igniter or burner assembly this repair
- $190–$410
- Oven thermostat or heating element
- $210–$470
- Refrigeration fan or defrost system
- $280–$680
- Dishwasher pump or control
- $180–$420
- Control board or touch panel
- $420–$640
- Compressor or sealed-system repair
- $1,360–$3,380
The $89 diagnostic visit is one flat charge for the trip and the complete fault-finding, and it is credited in full against the repair you approve.
Read a band as a boundary, not a price. The figure for your appliance is worked out at the appliance, written beside the measurement that justifies it and agreed before a panel comes off; the $89 diagnosis is then deducted from it.
Unsure which row fits? Describe the fault on a call to (206) 210-3547 (the line is staffed 24/7) and the likely row is named before a visit is booked.
07In their words
Edmonds kitchens, in their words
Written up after the invoice and edited only for length. Names are shortened at the customers' request.
5.0 / 51,147 reviews
Two burners had been clicking for months without ever catching. A cracked igniter and a spark module soaked by an old boil-over. He showed me the corrosion, fitted both from the van, and they light instantly now.
Turned up inside the window he gave, wrote the fault down with the measurement beside it, and did not try to sell me a service plan. The burner wanted one spark electrode and nothing else.
The simmer setting kept dropping the flame out altogether on the left side. A lazy gas valve, not the control board a previous shop wanted to order. Half a morning, and it holds a low flame again.
Range Repair in Edmonds: start with the $89 diagnosis
A call to Viking Appliance Repair Edmonds reaches a person at any hour; the booking page lets you choose a visit window yourself, and a technician rings to confirm the appliance before the day. The diagnosis is a flat $89, deducted from any repair you approve.
Visits 8 am–8 pm daily · line staffed 24/7
